Use limitations
09 February 2022
- Toner/Ink
- Photo Paper
- Continuous Ink Supply System (CISS)
- Refillable Cartridge Sets (RCS)
- Cleaning Kits and Wipes
- Tempered Glass
- Garland
- Power strip
- Car, wall, wireless chargers
Toner/Ink
- Keep items containing toner or ink out of the reach of children.
- If toner or ink is spilled, do not inhale or swallow it.
- Avoid contact with eyes and skin.
- In case of contact with skin, wash it with soap and water.
- Keep ink or toner tightly closed till the next use.
- Avoid the exposure to direct sunlight and heat.
- Avoid sudden changes in temperature and humidity.
- Please note that most toner cartridges should not be thrown away, but re-packaged properly and returned to shipping/receiving for recycling.
- Do not flush toner or ink.
- Toner cartridges should always be disposed off in an appropriate container or bin.
- Dispose empty ink or toner cartridges in plastic bags only.
- Do not try to force open or destroy items containing toner or ink.
- Do not add to the ink or toner any other fluids or acids.
- Do not try to set parts containing toner or ink on fire.
Photo Paper
- Keep paper in dark, cool, relatively dry areas.
- Avoid exposure to ultraviolet rays such as sunlight and fluorescent lamp.
- Do not leave the paper under the influence of a strong light for a long time.
- Upon storage the paper avoid sudden changes in temperature and humidity.
- Avoid storing paper in attics, kitchens, garages, and basements.
- Keep paper in its original packaging.
- Paper should be stored on shelves, or closets.
- Do not keep food or drinks near paper storage area. (?)
- It is recommended to store printed photos in photo albums, books, frames, special cases, envelopes etc.
- Don’t store photographs with newspaper clippings.
- Do not use scraps of paper for printing.
- Do not use paper containing clips, pins and other items.
- It is absolutely forbidden to use items not designed for printing.
- Do not open sealed packages until you are ready to load them into the printer.
Continuous Ink Supply System (CISS)
- Keep the ink out of the reach of children.
- Do not drink the ink.
- Do not eat containers.
- Avoid contact with eyes.
- Avoid exposure to direct sunlight.
- Do not tilt or turn the CISS during long-term storage.
- Do not locate external tanks higher or lower than printer level.
- Do not lift external tanks above the level of cartridges (print head).
- Air filters (their membranes) must be clean and dry. Avoid contact with water or any other liquid.
- Do not print without ink in the cartridges.
- Do not print with the excessive or low amount of ink in the cartridges.
- Print not less than once per week.
- Do not mix different types and brands of ink.
- Use only high-quality ColorWay ink.
- Do not turn the ink tanks during printing.
- Do not dismantle the ink cartridges of CISS.
- Do not touch and do not harm the chips of CISS cartridges.
Find out more about proper use of ink under the head Ink Use limitations.
Refillable Cartridge Sets (RCS)
- Keep all the items out of the reach of children.
- Do not eat cartridges.
- Do not keep empty cartridges outside the printer till refilling.
- Keep the cartridge in a 'print head down' position as much as possible.
- Do not leave cartridges out for days or week.
- Do not put your cartridges in plastic bags to avoid refilling problems in the future.
- Do not refill cartridges in the printer.
- Do not print with one color empty.
- Refill the cartridge when one color begins to fade
- Refill cartridges as soon as possible after running out.
- Do not print without ink in the cartridges.
- Do not print with the excessive or low amount of ink in the cartridges.
- Do not throw away the clip.
- Do not damage the inside film on the walls of the cartridge.
- Do not remove the clip with an open intake hole.
Find out more about proper use of ink under the head Ink Use limitations.
Cleaning Kits and Wipes
- Keep all the items out of the reach of children.
- Do not inhale or drink cleaning solutions.
- Avoid contact with eyes and skin.
- Avoid exposure to direct sunlight.
- Seal up bottles with cleaning solution till the next use.
- Do not mix cleaning solutions with other fluids.
- Do not mix cleaning solution with acids.
- Do not to apply the product to the areas and equipment not intended for use.
- Use only the microfiber cloth with the cleaning solution. Do not apply materials on hand.
- Do not overwork or apply excessive pressure to avoid damaging the surface or surface coatings.
- Do not press on the screen with your fingernails or other objects.
- Spray an adequate amount of the cleaning solution onto one portion of the cloth.
- Do not apply on heated surfaces.
- Do not use cleaning solution when your electronic device switched on.
- Do not allow liquid to run into the edges under the frame of the screen.
Tempered Glass
- Keep tempered glass out of the reach of children.
- Do not taste tempered glass.
- Make sure you have tempered glass required for your model.
- Do not install tempered glass on dirty screens.
- Do not install tempered glass with dirty hands.
- Do not install tempered glass in underlit areas.
- Do not install tempered glass in dusty environment.
- Do not install tempered glass on wet screens.
- Do not use adhesive tape or washi tape for screen cleaning before tempered glass installation.
- Do not touch any inner and an outer surface of the glass.
- It is not recommended to install tempered glass with device switched on.
Garland
- Remove the garland from the packaging and check the insulation integrity of the power cord.. Pay special attention to the insulation and connection of wires.
- It is forbidden to operate the garland with a damaged power cord or damaged cable insulation. It is forbidden to cut the garland
- Mount the garland at the place of use. When installing, make sure that the garland cord is not subjected to increased mechanical stress.
- Restrict access to the garland to small children and pets. Do not allow children to connect garlands to the mains, it can be dangerous
- Connection of garlands for voltage 220V must be carried out through a residual current device (RCD) or a differential circuit breaker. The use of these devices will avoid electric shock in case of accidental contact with live parts, insulation damage and short circuit.
- When decorating outdoors, such as the front of your house, do not use garlands and extension cords designed for indoor use. Use garlands according to the instructions for use and the degree of protection against moisture.
- The garland should be far away from heaters, open flames
- Do not use a large number of garlands at the same time: a short circuit may occur due to overheating of the networks
- If you leave the house or go to bed, do not leave the lights on
- It is recommended to periodically turn off the garland to avoid melting the plastic or igniting the tinsel.
- In case of malfunctions (heating of wires, not natural blinking of bulbs, etc.), de-energize the garlands
Power strip
- Do not connect the power strip to a network with a voltage higher than the nominal
- It is recommended to connect the power strip to a grounded power supply. It is important to understand that in the absence of grounding in the house and in the outlet, the power strip with grounding will not be able to perform these functions.
- Power strips with identification less than IP65 are not recommended for outdoor use
- The total power of simultaneously operating devices must not exceed the maximum power specified in the characteristics of the power strip.
- After you have connected the power strip, check the tightness of the contact, at the junction of the plug with the socket
- Do not touch the power strip with wet hands.
- Do not use in places where liquids, moisture, dust and exposure to high temperatures are possible
- During use, make sure that the devices are securely connected to prevent poor contact with the risk of short circuit or fire.
- Do not cover the power strip with anything during use.
- Do not use a surge protector with signs of mechanical damage.
- Do not disassemble or repair yourself
- Be careful not to leave the cord of the power strip where it can be chafed or pinched.
- If you are using a power strip on the floor, try to do it in a place as far as possible from the paths of people, animals and things.
- Keep the power strip out of the reach of children and animals
- If there is a block with USB charging in the power strip, please read the "Restriction on the use of Chargers"
Car, wall, wireless chargers
- Do not connect the charger to a network with a voltage higher than the nominal one, follow the information indicated in the technical specifications
- Do not use the charger where it may be exposed to liquid, moisture, dust or high temperatures (open flames, heaters, direct sunlight). The charger works best at temperatures between 0 and 35°C. Do not leave the charger in places where the temperature may exceed 45°C
- Do not drop the charger or subject it to strong impacts
- Do not attempt to service or repair the charger yourself
- Never modify the charger
- Use the charger only for its intended purpose
- Route all cables (supplied) in such a way that they cannot be caught or tripped over
- Do not bend or pinch the cable (supplied)
- When disconnecting the cable (supplied), always pull directly on the plug, not on the cable itself
- Do not connect or disconnect the charger with damp or wet hands
- The charger is for indoor or vehicle use only
- Do not use the charger where the use of electronic devices is prohibited
- Do not use the charger if the power cord, power source, or end device is damaged or otherwise defective
- Do not sleep on the charger, or place the charger under a blanket, pillow, or your body while the charger is connected to a power source
- When using a wireless charger, remove metal cases and avoid placing metal foreign objects (such as keys, coins, or jewelry) on it as they may become hot or prevent charging
- Unplug your device during a thunderstorm or if you are going to leave the charger for a long time. Do not clean the device with harsh chemical cleaners. Do not clean the device while charging
- The charger in the box may contain small parts, plastic parts, or sharp-edged parts that could cause injury or block your airway. Do not leave the CHARGER or accessories within the reach of children or allow them to play with them. Children can injure themselves or others, or accidentally damage the charger